Search results

Create the page "Test probe" on this wiki! See also the search results found.

• JTAG
  '''JTAG''' (named after the '''Joint Test Action Group''' which codified it) is an [[Technical standard|industry stan ...ements a [[State (computer science)|stateful]] protocol to access a set of test registers that present chip logic levels and device capabilities of various
  48 KB (7,407 words) - 20:45, 19 August 2018
• LOCATING EMMC TEST POINTS PULLOFF
  ...It does not matter which one you use. Using a continuity tester, place one probe on each of the exposed points on the board listed above and touch each of t ...ing board. It is not recommended to use the exhibit for this, but a second test model. Leaving the eMMC chip in place, apply power to the board either from
  3 KB (491 words) - 09:33, 10 June 2019