Z3X-box

Z3X Box

service tool for phone boot and chip firmware repair and data recovery. 

Z3X Box is a tool that allows the owner of a Samsung or LG phone to customize their device. With a Z3X Box, a user can repair options on a device that may be causing software difficulties, unfreeze a phone that is no longer responding, unlock a phone or flashing it (when it no longer works, only with its original service provider).

Keep in mind that using a Z3X Box to significantly alter one's cellphone may void the item's warranty. Always check with the terms of the warranty before using a Z3X Box or other device or program on one's phone. 

А variant form of Z3X Box look like

1. USB Hub for connect any usb device
2. TX LED transmitting data
3. PWR LED power led
4. RX LED receiving data
5. Card LED card request
6. Service cable UART

Appearance may vary. Just sure you make purchase from our official resellers

sample Z3X BOX

Setting Up a Z3X Box

Setting Up a Z3X Box After buying a Z3X Box, the user will need to set up the program's shell. This shell is available on the Z3X website for free, along with other files; these do not come with the device itself.
Download and install this program onto a computer (not onto the phone). Depending on what drivers are installed on the system, Z3X Shell may prompt the user to download and install some drivers at this stage; this should be completed before using the Z3X Box.
Tether the phone to the computer with a USB cable and run The Shell program that was just installed. The Shell will run the user through the Z3X Box setup procedure, and may ask some basic questions about the device, including make, model, and operating system. Once this process is complete, the Z3X Box will be ready to use with one's phone

Unlocking a device with a Z3X Box

One of the many customization options available with Z3X Box is unlocking device. To do this:

1. tether the device to the computer that has already set up the Z3X Box shell, and run the Shell program
2. ensure that the correct make and model of device are selected
3. select the Direct Unlock option in the shell
4. the program will prompt the user to press and hold the power button for three seconds

Doing this will begin the unlocking process, which may take several minutes. The shell will inform the user once the process is complete.

Please note:
Do not untether device or close the shell before receiving this message, or the device may not successfully unlock.

Flashing a Samsung Phone with Z3X Box

Z3X Box development team advises unlocking the phone before flashing it, so follow those steps first. To flash the phone, be sure to first download the necessary flash files online from Z3X website. The precise files to use will depend on the model of phone owned, so read the instructions carefully on the site.

Tether the phone to the computer and run the Z3X Box shell. Under the section that says Flash Files, select the flash files that have been downloaded for the phone. Then click Flash on the righthand side of the page, to install these files onto the phone.

Useful and important links:

Installation guide
Samsung Tool Pro
LG Tool
Dictionary
How to buy